KSHP. OMD №3-2015

CONTENTS № 3–2015

THEORY, CALCULATIONS, RESEARCHES

Baranov G.L. Improvement of methods of calculating stresses in tasks of flat plastic deformation, p. 3–9

Zhbankov I.G, Markov O.E., Martynov S.V. Investigation of open die forging discs by upsetting with flat anvils in low power equipment, p. 10–15

Poksevatkin M.I., Basova E.M., German S.V., Poksevatkin D.M. Rationalization of the longitudinal profile of the deforming cone in monolithic drawing dies, p. 16–19

TECHNOLOGY OF PROCESSING BY PRESSURE

Mitin O.N. Manufacturing power modes of parts with internal fluting, p. 19–22

Demynenko E.G., Popov I.P. Development of the process of forming thin-walled convex parts from conical blank, p. 22–26

TOOLS AND TECHNOLOGICAL RIGGING

Tyurin V.A. Opportunities of increasing of the deforming tool resistance in conditions of cyclic loading, p. 26–30

SIMULATION OF TECHNOLOGICAL PROCESSES. CAD SYSTEMS

Simonova L.A., Hisamutdinov R.M., Sungatov I.Z. Simulation of the formation of the special disk tool on the stage of technological preparation of production on the example of spherical cutter, p. 30–33

Berdin V.K., Berdin N.V., Lukyanov V.V. Elastic-viscoplastic material behavior in numerical simulations of processes of uniaxial compression, tension and pure shear, p. 33–42

HEATING AND HEATING DEVICES

Agunovich I.V., Vereschagin, M.N., Babarikin Y.L., Avseykov C.C. The effect of preheating on structure and properties of wire from steel 90K with brass floor, p. 42–45

CHRONICLE

Artes A.E. 20-th international industrial exhibition «Metal-Expo» 2014, p. 45–48