CONTENTS № 5–2025 

SIMULATION OF TECHNOLOGICAL PROCESSES. CAD SYSTEMS 

Vasiliev D. V., Kireev V. V., Zyryanov V. A. Increasing the durability of hobbing cutters based on a progressive cutting scheme and determining the stress-strain state of the cutter teeth, p. 3–8
Lutyanov A. V. Features of compressed air flow in bearings with cylindrical supports, p. 8–13
Xu Xiaoshu Analysis of failure and fatigue behavior of aerospace composite shells based on finite element method, p. 13–16

NANOTECHNOLOGIES AND NANOMATERIALS

Svistun L. I., Ozolin A. V., Sokolov E. G., Golius D. A. Kinetics of mechanical grinding of tungsten powder in a planetary ball mill, p. 17–23

MICROSTRUCTURE FEATURES OF MATERIALS

Smirnov D. V. Formation of lanthanum-containing matrix by RMI method, p. 24–28

EQUIPMENT

Kiselev G. G., Astrakhansky A. Yu. Fuel consumption monitoring for internal combustion engine power systems of ground-based transport and technological vehicles, p. 29–32

THEORY, CALCULATIONS, RESEARCHES

Kanareykin A. I. Statistical criteria for the strength of brittle materials, p. 33–35
Kanareykin A. I. Determination of heat transfer in the rod for the case of a linear change in the thermal conductivity of the coating layer, p. 36–38
Lim A. A. Dynamic dependency graphs for AR-support of FDM extruder assembly, p. 39–43
Sevostyanov I. V. Influence of cutting modes on the accuracy of a complex-profile product, p. 44–48